Enter, find, then Ģ.Select, and then select Gearbox type according to the specific model, here we choose to enter the function menu. Situation 1: the customer’s original vehicle gearbox data is readable and the data is not damaged, the gearbox can be clonedġ.
LAUNCH X431 PRO 3 ODOMETER CODE
In this situation, we need to back up the EEPROM of the ECU for replacement, and then manually input the original CS code or get the original CS code from the original key. The data of the customer’s original vehicle gearbox ECU is unreadable or the data is damaged. In this situation, we just need to back up the original gearbox EEPROM and FLASH, and then restore them into the gearbox ECU for replacement.Ģ). Data is not damaged, and the gearbox can be cloned. The data of the customer’s original vehicle gearbox ECU is readable. There are two kinds of gearbox ECU replacements, and the customer can choose one of them according to the actual situationġ). Here we take the DQ200-MQB Gearbox as an example, replace its ECU and finish the settings.Īudi V28.70 and above, IMMO PROGRAM V10.02 and above. According to a LAUNCH study, as of May 2021, no other competing tester manufacturer’s product can do this. The BOSCH engine control module can also be adapted to the vehicle, both new and used.
Not only new but also used control modules can be adapted. (Before the update, only a limited number of control modules were available). With this important update, after replacing the control module of the transmission, which is commonly installed in various models of the VW Group, it is now possible to adapt it to the vehicle by using the X-PRO G3 together with X431 tablets ( X431 PAD V, PAD VII etc). LAUNCH X-PROG3 has an important update- VW Audi MQB gearbox replacement.
0 kommentar(er)
